Renusol FS
flat roof system with optimised statics
Due to a rail system and aerodynamic optimisation, the Renusol FS system is particularly suitable for larger and large flat roofs with limited load capacity. It is fixed with ballast and is statically secured by tests in the wind tunnel.
Variants & applications
- Fairly low load capacity of the roof (because lighter)
- Fairly high tenancy (better utilisation of surface)
- Own consumption (production more continuously distributed over the day)
- Full covering of the roof surface is not reasonable (e.g. because of limited own consumption or limited funding)
- Full covering of the roof surface is not reasonable (e.g. because of limited own consumption or limited funding)
Renusol FS 10-EW/10-S/18-S with third rail
can be combined with all Renusol FS variants
Renusol MS+P
Combination with Renusol MS+P for installation on low-pitched metal roofs, combinable with all Renusol FS-variants.
Renusol FS „Long version“
Less shading and less ballast.
Renusol FS with roof connector
Advantages for you
To be mounted easily and fast
(e.g. plug bolts instead of screws, can be mounted nearly without measurements)
Fewer parts, short rails
simple logistics
Minimum distance of 60 cm from roof edge to panel/system
OptimiZed ballast, light-weight, but not too light, and safe
(on request also available without ballast with roof fasteners)
Transparent report on structural calculations ready for approval
No „creeping“ in case of temperature-dependent expansion due to short rails with connectors
Protection of roofing by wide bearing faces and various protective mats
Renusol FS10-EW Installation Video
Reference project:
930KWP NOUA HALA ARCTIC
October - November 2018
