Renusol FS
flat roof system with optimised statics

Due to a rail system and aerodynamic optimisation, the Renusol FS system is particularly suitable for larger and large flat roofs with limited load capacity. It is fixed with ballast and is statically secured by tests in the wind tunnel.

Variants & applications

East-West
Renusol FS 10-EW

- Reasonable with high and low angle of solar incidence (South and North Europe)
- Fairly low load capacity of the roof (because lighter)
- Fairly high tenancy (better utilisation of surface)
- Own consumption (production more continuously distributed over the day)

South 10°
Renusol FS 10-S

- With fairly high and medium angle of solar incidence (e.g. South and Central Europe)
- Full covering of the roof surface is not reasonable (e.g. because of limited own consumption or limited funding)

South 18°
Renusol FS 18-S

- Fairly low angle of solar incidence (e.g. North Europe)
- Full covering of the roof surface is not reasonable (e.g. because of limited own consumption or limited funding)

High snow load

Renusol FS 10-EW/10-S/18-S with third rail

High snow load up to 5,400 Pa/m²;
can be combined with all Renusol FS variants

Fixed on trapezoidal sheet metal
Renusol FS plus
Renusol MS+P

Fixation on metal roofs.
Combination with Renusol MS+P for installation on low-pitched metal roofs, combinable with all Renusol FS-variants.

Extended distances

Renusol FS „Long version“
 

On request, longer base rails allow wider module distances.
Less shading and less ballast.

Fixation instead of Ballast

Renusol FS with roof connector

Roof connector fixed without additional weight. e.g. Nicholson Rooftrak®

Cost-effective
Renusol FS without Streamliner
 

Optionally more cost-effective without wind deflectors. With this, ballast is a bit heavier; just check it in the PV Configurator!

Advantages for you

To be mounted easily and fast
(e.g. plug bolts instead of screws, can be mounted nearly without measurements)

Fewer parts, short rails
simple logistics

Minimum distance of 60 cm from roof edge to panel/system

OptimiZed ballast, light-weight, but not too light, and safe
(on request also available without ballast with roof fasteners)

Transparent report on structural calculations ready for approval

No „creeping“ in case of temperature-dependent expansion due to short rails with connectors

Protection of roofing by wide bearing faces and various protective mats

Renusol FS10-EW Installation Video

Reference project:

930KWP NOUA HALA ARCTIC
October - November 2018

Reference project Renusol FS10-S


Flat roof


Further reference projects

Reference project Renusol FS10-S


Flat roof


Further reference projects

Reference project Renusol FS10 IFP


Flat roof


Further reference projects

Reference project Jaha Solar


Flat roof


Further reference projects

Reference project Envirolec


Flat roof


Further reference projects

Reference project Envirolec


Flat roof


Further reference projects

Reference project Renusol FS10-EW Lakeside


Flat roof


Further reference projects